Description:  A tilter press contains a set of plates designed to provide a

series of chambers or compartments in which solids may collect. The plates

are covered with a filter medium such as canvas cloth. Slurry is admitted to

each compartment under pressure; liquor passes through the canvas cloth

and out a discharge pipe, leaving a wet cake of solids behind. Plates and

frames sit vertically  in a metal rack, with cloth covering the face of each

plate, and are squeezed tightly together by, screw. Slurry enters at one end

of the assembly of plates and frame. It passes through a channel running

lengthwise through one corner of assembly.

Features:  The  set  up  consists  of  7  plates  and  6  frames. Frames  are

covered with  filter  cloth.  Feed is fed b  gear pump at  the top and filtrate

collected  at  the  bottom  from  each  plate  by  operating  the  cock.  After

removing Cake, washing and cleaning can be done by water provided by

overhead tank. Inlet & outlet pressures are measured by pressure gauges.

Rate of filtrate removals is measure by calibrated tank provided.

SPECIFICATIONS:

1.   Frame            : 6 Nos.

2.   Plates            : 7 Nos( Size 200 mm x 200 mm.)

3.   Material            : Acrylic (MS/SS on request)

4.   Filter Medium          : Filter Cloth, Filtrate Collection Tray

5.   Slurry Feed Tank       : Material SS, Suitable size.

6.   Slurry Tank Agitator    : Material SS, Capacity 40 Ltrs.

7.   SS Impeller             : with SS Shaft coupled to FHP

8.   Screw Jack Arrangement  : For tightening &  removing of frames

9.   Slurry Feed Pump      : Motor and Reduction Gear BI

10.  Gear Pump             : with FHP standard Make motor.

11.  Piping System          : GI and PVC

12.  Pressure Measurement  : Bourdon type pressure gauge

13.  Overhead Water Tank  : Material SS  , Capacity 25 Ltrs

14.  Control Panel           : On / off , Mains Indicator & fuse etc