Descdription:Closed Circuit Type With S.S. Tanks, ISI Mark Pumps & Motors,Powdercoated The closed circuit test rig consists of a monoblock centrifugal pump. The pump isprovided with a vacuum gauge on suction pipe and a pressure gauge on discharge pipe.The gate valve is used to adjust the head on the pump. The discharge is measured bymeasuring t..

It consists of a pair of M.S. plates, Bakelite, brass/aluminum. These plates in series on either side of the heater form a composite wall & is clamped in a frame, which can be viewed through the Perspex sheet. The thermocouple  enables us to find out the conductivity & resistance of the composite walls.SPECIFICATIONS:1.  Heat..

DESCRIPTION:-Francis Turbine is a reaction Turbine, which was developed by English born AmericanEngineer Sir J.B. Francis. The water enters the turbine through the outer periphery of therunner in the radial direction and leaves the runner in axial direction and hence it is called amixed flow turbine. As the water flows to the runner, a part of pres..

DESCRIPTION:- The Set-up is designed to study the performance of Gear Pump.The Set-up consists of a Gear Pump having a pair of meshed gears coupled withelectrical motor, supply tank, measuring tank & pipe fittings for closed loop oilcirculation. Pressure and Vacuum Gauges are connected on delivery and suctionside of pump for the purpose of meas..

OBJECTIVE:  To conduct the experiment of hydraulic bench, with separate experiential set ups i.e. Hydrostatic Pressure, Flow over Weirs, Bernoulli's Theorem, Flow meter Demonstration, Impact of jet and Orifice Discharge etc. which are accessories of the Hydraulic Bench.DESCRIPTION OF APPARATUS : The set up is a self-contained, water recirc..

DESCRIPTION:- The Set-up is designed to study the Hydraulic Ram. Hydraulic RAM is used for pump little quantity of water to high head from a large quantity of water available at low head. It works on a principle of water hammer stating that “When flowing water is suddenly stopped in a long pipe a pressure wave travels along the ..

DESCRIPTION:-Kaplan Turbine is an axial flow reaction Turbine named in honor of Dr. B.Kaplan, a Gennan Engineer. This turbine is suitable for low head. The power produced bya turbine is proportional to QH. As the head (H) decreases the J discharge (Q) mustincrease to produce the same power. The present Set-up consists of a scroll casinghousing a ru..

DESCRIPTION:- The Set-up is designed to study theperformance of Multi Stage Centrifugal Pump. The Set-upconsists of a Multi Stage Centrifugal Pump coupled with DCmotor & drive, supply tank, measuring tank & pipe fittings forclosed loop water circulation. There are 2 separate pumpsconnected to DC Motor and drive and can be connected in serie..

Pelton Wheel Turbine is only impulse water turbine now in common use named in honorof Sir L.A. Pelton (1829-1908) of California, USA. It is a tangential flow impulse turbine.The energy available at the Inlet of the Turbine is only kinetic energy. The Pressure atthe Inlet and Outlet of the atmospheric. The Present Set-up consists of a runner. Thewat..

Description:  A tilter press contains a set of plates designed to provide a series of chambers or compartments in which solids may collect. The plates are covered with a filter medium such as canvas cloth. Slurry is admitted to each compartment under pressure; liquor passes through the canvas cloth and out a discharge pipe, leaving a wet c..

DESCRIPTION:- The Set-up is designed to study the performance ofReciprocating Pump. The Set-up consists of a Reciprocating Pumpcoupled with electrical motor, supply tank, measuring tank & pipefittings for closed loop water circulation. Pressure and Vacuum Gaugeare connected on delivery and suction side of pump for the purpose ofmeasurement. The..